i was checking my block today, i realized when i got my motor rebuilt like 3 months ago, the rebuild company bored my block fucking 50 over...i have no idea why they did they, they also fucked alot of other things up...

anyways, i have eagle rods on order

i need some forged pistons , where can i get pistons for a 50 over block, i only found some for 40 over...

can JE custom make the or what?

holy cow!

i no its wack, im pissed, im going to get a full refund or im sueing them cuz thats fucked up

so where can i get pistions for 50 over?

who did the work?


Undergoing MAJOR modifications, inside and out: Sneek peek at phase 1 and 2 shown;
End of Project Goal - 4/23/04
member# 2498 / girl member# unknown

well, my first gen talon had an overbore of .050..go figure

im gonna say nowhere. i've seen 60 over, so i'd take it back to the bishes and be like fix my shit right now or we're talking legal troubles. they should foot the bill IMO.

http://www.importperformanceparts.net/

"We can make you a forged Piston for any stroke, bore or compression ratio. These can be used for street/strip injected blowers or turbo charged"


I guess they can make em- ill have to give em a call tommrow morning


as far as i no, theres nothing to bad about 50 over but, its the fact that its just to big...my cyn walls are weaker now, but not alot...

Originally posted by xtrickedeclipsex
http://www.importperformanceparts.net/ "We can make you a forged Piston for any stroke, bore or compression ratio. These can be used for street/strip injected blowers or turbo charged" I guess they can make em- ill have to give em a call tommrow morning as far as i no, theres nothing to bad about 50 over but, its the fact that its just to big...my cyn walls are weaker now, but not alot...

fuck that ROSS and JE will make custom pistons and they can withstand just about anything

also 50 isn't that bad but you won't be able to overbore the block again for a rebuild, they basically made so you will have to buy another block when this one dies but that is in like 250K or sooner if you blow it

Did you let them know prior to machine work if you wanted it bored out? Someone out there should be able to make custom pistons for you just do some good searching.


*rebuild in process*
GST Muffler
injen short ram intake
magnecore 8.5mm wires
EGR removal/blockoff
front/rear strut tower bars
GSX dual piston calipers