Ok i know this has been posted many times over but my interrests have not yet been satisfied. I am looking for someone who has or is running the emanage with the software tool and using it to compensate for boost.

My Goal: to use the Emanage to adjust fuel based on boost (like a turbo ECU), to datalog, adjust for larger injectors.

How does the boost sensor work in the unit, how does it interface. i know how boost pressures work :). The additional injectors, i want to run 4 additional injectors the react to boost or can i make the 4 primaries react off the boost sensor (i prefer the latter).

I think making the primary injectors react to boost in addition to their parameters would create a 3d map and the emanage will not do that right?

How easy was initial setup, How much data can you log (knock?).

I would like to find someone who could give me there schematics and instructions to view. Do you use the same wiring that the AFC would wire into. I know the emanage works on our cars but its hard to find help on it.

I have an Super AFC but i was thinking i am better off buying the emanage and selling the AFC.

Thanks

Terry

nobody?.. i know some members are using this....not sure if i truest the Apexi AFC i have.

Terry