Go back to previous topic
Forum namePerformance/Engine
Topic subjectif you have done a rebuild, double check my gaskets with me please?
Topic URLhttps://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=66369
66369, if you have done a rebuild, double check my gaskets with me please?
Posted by tim97rs, Jan-11-04 04:17 PM
this is jus ton the block so far with oil and h20 pump:

pink o-ring at oil hole between bedplate and block.
o-ring between bedplate and oil filter seat.
water-pump o-ring.
anerobic sealer between bedplate and block.
oil siphon tube o-ring.


did i miss anything?
66374, RE: if you have done a rebuild, double check my gaskets with me please?
Posted by dougie2, Jan-12-04 02:01 AM
Don't forget anaerobic sealant between oil pump and block. Also, don't forget the rear main seal.
66378, RE: if you have done a rebuild, double check my gaskets with me please?
Posted by Michael_97RS, Jan-12-04 03:09 AM
Yeah front and rear main seals, also o-ring on the oil pump pick up tube, O-ring on water pump outlet tube, and water pump seal to block. The obvious oil pan gasket. These are probably more than you were looking for.



Exile Racing Technologies: http://www.exileracing.com
una salus victus
Mods List: http://highlander.dsmpower.com/sig.htm
66382, RE: if you have done a rebuild, double check my gaskets with me please?
Posted by thedawg, Jan-12-04 05:17 AM


Hope I didn't kill any 56k'ers ;)
66395, RE: if you have done a rebuild, double check my gaskets with me please?
Posted by tim97rs, Jan-12-04 08:39 AM
was i supposed to use anerobic on the oil pump to block? i just used regular sealer. otheriwse i got all the other one listed so far.