Is there any way to check the CR of a piston by looking at the piston itself? How would you know if somehow some 8.8:1 pistons got put in a box by mistake with a spec sheet for 10.5:1? What numbers would you check on the spec sheet to see? Assuming this isn't listed on the box?

Thanks again! :P

Isn't the size of the piston actually a little shorter if the compression is lower? Cuz you know, it's not compressing as much. :shrug

8.8:1 pistons are a dished design. the middlke is actually sunken down.

10.5:1 are domes pistons, like the stock design but with a higher dome.



http://www.exileracing.com
una salus victus
Mods List: http://highlander.dsmpower.com/sig.htm

Whew! Okay then! I think that's a relief to know. :P

Thanks folks!