Go back to previous topic | Forum name | Performance/Engine | Topic subject | S-AFC INSTALLED, CEL CODE 14, whats wrong? | Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=5&topic_id=63167 |
63167, S-AFC INSTALLED, CEL CODE 14, whats wrong? Posted by dannyalberici, Dec-31-69 06:00 PM
OK I just put in my s-afc and I get thrown codes 12, 14, and 55 on the CEL. 14 is MAP sensor voltage too high. What could be wrong? The wiring or the tuning? I have all corrections set to +-0%.
|
63168, RE: S-AFC INSTALLED, CEL CODE 14, whats wrong? Posted by ner947, Dec-31-69 06:00 PM
definately not "advanced tuning". this probably belongs in "peformance/engine".
check your "in/out" settings. when i still had my AFC, i used 5 in and 5 out. other people have had success with 6 in and 6 our or 7 in and 7 out.
another common thing is how you installed the ground for the AFC. if i remember correctly, there are 2 different grounds, one for the MAP refrence and one to run the AFC itself. if you just ground both to the frame somewhere, you will get a "MAP RAN" (MAP range) code. i had this "problem", it didn't affect the operation of the AFC or the ECU, but it did give me that annoying CEL that i eventually became used to.
| |