Ok i got some of those cam gears that have to wrong setting how did u guys go about putting the right marks on the cam gears also does the puller that i used for my stock udp work for my AFX udp its on of the 3 arm pullers.
Thanks

What I did was line up the stock cam gear with the aftermarket one (place one on top of each other, with the hole for the dowel pins in the same position), and VERY CAREFULLY etch a mark on the aftermarket cam in the exact place where the mark is located on the stock gear.

And, for the pulley, I'm guessing you could use the gear puller, but you should really look into using a harmonic balancer puller which has long bolts that come with it, which will screw into the threaded holes onthe AFX pulley. You can usually find a harmonic balancer puller at autozone, and they are easier to use than the 3 jaw gear puller.

Has this problem not been fixed yet? Are all brands of cam gears like that?

just AEM cause they are for Neons.