So I was having some werid issues with my A/F Ratio guage. It works aslong as I hold the wire coming from the cumputer A/F wire under the hood in one hand and the other wire coming from the guage in my other hand. But when I connect the wires togather the guage only reads SUper Rich. The guage is a Sunpro guage, I'm not sure if that means it need adapter or the guage just sucks...

do you have it grounded good?

do you have a good power source?

is the air/fuel wire spliced into the white wire with black stripe on the pcm?

that's all i could think of. unless the gauge is faulty?

later

higher a midget to sit in your engine bay and hold those two wires:7

nah probably just need a better ground on the ecu or gauge