| Go back to previous topic | | Forum name | Performance/Engine | | Topic subject | head package | | Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=53154 |
53154, head package
Posted by RudoraEclipse, Jun-13-03 07:54 AM
I am wanting to buy a new head package but I dont know where to look for a good price. Anyone have any ideas?? I am also wanting to turbo my car so I need a head that would go good with a stage 3 Hahn kit.
|
53159, RE: head package
Posted by Matt_95tgs, Jun-13-03 08:21 AM
Honeltly, the stock head will go good with a hahn stage 3. People have run 9's with the stock 420a head and valvetrain so upgrading isnt a necessity. However, if you are like me and dont want a stock head anyway, I can personally vouch for crane valve springs, pt lifters and rockers, stainless valves and crane #14 cams. There are a few vendors on this board that can sell you all of this stuff.
|
53164, RE: head package
Posted by 2g99RSNC, Jun-13-03 10:26 AM
here is a site that has some
http://www.mmrusa.com/gudehead.htm
|
53168, RE: head package
Posted by DarkOne, Jun-13-03 11:49 AM
It'd run a stock head over a GUDE head any day. Probably make more power, too.
|
53332, RE: head package
Posted by RudoraEclipse, Jun-17-03 11:26 AM
Honeltly, the stock head will go good with a hahn stage 3. People have run 9's with the stock 420a head and valvetrain so upgrading isnt a necessity. However, if you are like me and dont want a stock head anyway, I can personally vouch for crane valve springs, pt lifters and rockers, stainless valves and crane #14 cams. There are a few vendors on this board that can sell you all of this stuff.
If I did this how much power could I expect and whats the difficulty in putting it in? Also around how much am I looking to spend? Another thing, can I run higher PSI when I turbo it if I do this?
|
53338, RE: head package
Posted by DSMkarz, Jun-17-03 01:06 PM
the head should go in the way it came out. If you going w/ all thoughs mods p&p the head and intake the turbo will love you for it. And you probably shouldnt turn boost up w/out a good bottom end. For high boost look into ceramic coating for the pistons and combustion chambers. As for price(on parts) shop around then buy. For p&p and machening look at only the best they say VT engines are good When my motor is built I will have Koffel's Place2 in Huron Ohio. As for price all i can say is how fast do you want to go. Good luck!
|
53344, RE: head package
Posted by etx, Jun-17-03 02:28 PM
VT engines can get you any parts you need and do the machine work you need. give them a call and they will set you up with a nice motor. thier prices are good too. vtengines.com
| |