I am taking my engine block tomororw (Friday)
and I just have a simple question.
I only have my block in my car right now, everything is off.
I will lift the engine block out with the lifter.
THen I will take all the crank and piston and rods out.
Is there anything I need to keep in mind of??
Anything that need SPECIAL care other then just "UNSCREW" and take it apart?
Thanks guys.
Gilbert

you need a puller for the crank sprocket and one for the crank pulley if you haven't already removed it.

tourqe wrench if you plan on putting it back together rite.. :)





97' Eclpse GS 420A
MODS*****
AEM cam Gears,MSD ignition,Chikira 4-2-1 header,Custom 2.5" exhast,Pacsetter hifloc

OK, so let me make this simple and say Agree or not. Thanks guys.

When I dis-assmeble the engine block (crank, piston, rod, bearing, rings, etc) All I need is a regular wrench, and just unscrew everything and take them out?? no special tools needed? extra care on?

When I assemble the engine block back (crank, bearing, rod, piston, rings, etc) All I need is a torgue Wrench? IS that all I need? anything special, extra care and so on?

Thanks guys.:thumbsup

Hopefully, I get the block out peacefully.

So, anyone with inputs to my above questions!
Thanks guys! :thumbsup :thumbsup
You guys are the best!

Gil:7 :7

I hate to say this but I am scared for you....
If your not 100% sure one something you better ask of course just my opinion.


Nick
97RS

Good news...after changing to the 5ton puller, I finally got the crank pulley out.. .YES... one thing out.... MORE TO GO!!!

So, any thing about disassemble the engine block???? Thanks guys.
Gil

>I hate to say this but I am scared for you....
>If your not 100% sure one something you better ask of course
>just my opinion.

I think its great. He's learning an assload.