I just got my car back from the dealership and 2 days later the CEL goes off, i got emisions checked to check the code and the code is P1294.... does ANYONE happen to know what this code means or where to find it????
THANKS

DTC DTC Title
P1294

Target RPM not achieved during drive idle condition (possible vacuum leak or IAC

thank you, whats IAC, and where would the vaccuum leak be? i first noticed the high idle(wich i do have when slowing down, but it returns to normal when i stop) when i was on the drag track and i puked the alternator belt when i went into 1st gear instead of 3rd gear, my timing belt also was off timing and i needed a new belt. so could anyof this caused it? thanks.

The IAC is a sensor motor on the back of the throttle body. It is the intake air controller. If you look on the back of the throttle body(towards the firewall), you'll see a small black box w/two torx screws w/wires coming off it. Thats the IAC.
A vacuum leak can be anywhere. My car his a high idle becuase i just got a new throttle body and it doesnt seal well. First listen for air leaks. If not, then youll have to look for ccracked hoses/bad gaskets, etc.
Someone else could answer the timing problem better than me.
Good Luck