Go back to previous topic
Forum namePerformance/Engine
Topic subjectHow many times have you gotten a leaky cam seal?
Topic URLhttps://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=50211
50211, How many times have you gotten a leaky cam seal?
Posted by Kiku, Apr-30-03 05:11 PM
Just curious if you folks who are boosted (or even non-bosted) keep getting the damn intake cam seal leaking! F'kin anoying if you tell me....specially to fix it.

Vinnie

Poll question: How many times have you gotten a leaky cam seal?

Poll result (8 votes)
Never (7 votes)Vote
1 time (0 votes)Vote
2 times (0 votes)Vote
3 times (1 votes)Vote
4 times (0 votes)Vote
More times than i care to bother fixing it! (0 votes)Vote

  

50221, RE: How many times have you gotten a leaky cam seal?
Posted by dougie2, Apr-30-03 06:27 PM
Are you sure you're not damaging it during installation?
50225, RE: How many times have you gotten a leaky cam seal?
Posted by Kiku, Apr-30-03 06:45 PM
I've done a lot of head gasket swaps...and i always replace 'em.

Service manual instructs to install the cams and all, torque 'em down. THEN install the cam seals without binding any one side i.e. install it evenly.

Here's my question....i have installed it with the spring facing IN and OUT and both have caused me problems. What have you guys done?

Also how far in do you install your cam seals? just flush to the side of the cyl head? or all the way in?


_________________
Vinnie Lima
vinnie.lima@jvllogistics.com
AIM: Kiku888
1997 Chrysler Sebring "Silver XTC"
I4 420a w/ HRC Stage 2.45 w/ FMIC
14.7@97 mph@6psi
Proud member of the
ASOG BoOsT JuNkIe Crew
50230, RE: How many times have you gotten a leaky cam seal?
Posted by juggalo, Apr-30-03 07:13 PM
spring in, all the way. i think part of it is the quality of the seal. i found out cheap seals usually don't hold for long.
50237, RE: How many times have you gotten a leaky cam seal?
Posted by optimuspeterson, Apr-30-03 07:55 PM
never had a leak one, i've been turbo'd also
50268, RE: How many times have you gotten a leaky cam seal?
Posted by XtremeRS, May-01-03 08:00 AM
Its important to keep the seal with the spring side in,and that the inner lip of the seal is not turned in, or binding with the cam journal. The seal needs to be in at least an 1/8" from the metal edge of the head. The seals are actually pretty good seals (OEM), and shouldnt leak for thousands, and thousands of miles, if installed properly.
50280, RE: How many times have you gotten a leaky cam seal?
Posted by Michael_97RS, May-01-03 10:08 AM
I don't hink mine are... I'll find out in the next couple of days, I have installed a few others and not had a problem wth them (that I was told about). Spring in, I actually don't follow install instructions. I install cam seal around cam and then slide cams into place, put the cap on and torque down, then get a little screwdriver and tap on the seal from the outside to ensure it's seated properly.



15.9 @ 86.7mph

Injen CAI, 55mm TB, P&P Intake, Crower Cams, Hooker Header, ERT/Catco Cat, GS-T Muffler, AFX UDP, Crane Ign Amp, S-AFC