After installing my AFC, I got p108 codes and p106. It says its got something to do with the map sensors. do you think the wire connections are not good enough, an I should re solder the wires?

Right now my car cant hold idle witht the afc on, when I take it out I can idle with it sorta. any imput would be greatly apreciated. TIA

what do you have the in/out settings at you should be at 6/6.
and I would recheck your connections to the map and also the grounds the brown wire I believe has to be close to ground than the black wire, I think thats right I dont rememver which color but its in the manual.

do you have it set for pressure, 4 cyl pointing up and 6/6 in/out
if that doesnt work try either 5/5 or 7/7 for in/out settings

ok, I recalibrated the safc, the thing I found that caused my car to die was the throttle settings. It was at -%'s for some reason. I set all my values to 0% now my car idles fine. As for the codes, I know the 106 code is going to come out, cause "50%" of our cars who have afcs do..., but I dono about this 108. maybe I should re wire the map wire.