Got a question about installing camshafts. I got some new Crower stage 2's today. I've taken out stock cams and put them back in but I'm seeing on the spec card that the cams have to be degreed in 106*. What does that mean? Or should I just ignore it and put them in how I normally do cams. Same way I take them out and then line up the cam sprocket timing marks.

Drop and go, no indexing. Did you not believe me in the other thread? :P

It's just part of the specs given. Line up the pins and timing marks as you always would.



15.9 @ 86.7mph
97 Eclipse RS

Injen CAI, 55mm TB, P&P Intake, Crower Stage 2 Cams, Hooker Header, GS-T Muffler, AFX UDP, Crane Ign Amp, S-AFC

I can't even begin to imagine how much work it would be to degree two camshafts!