| Go back to previous topic |
| Forum name | Performance/Engine |
| Topic subject | fuel line fitting question? |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=4146 |
4146, fuel line fitting question?
Posted by 95ESi, Jun-26-01 09:05 PM
Would anyone know the thread size of the fitting on the hard line that you connect the softline from the pump assembly?
14mm x 1.5?
10mm x 1.5?
16mm x 1.5?
___________________________
l e o n
1995 Eagle Talon ESi-T
Star Stage 2
Boost is GOOOOOOOD!
|
4147, RE: fuel line fitting question?
Posted by Hoot, Jun-27-01 03:24 AM
it's a 14mm x 1.5 inverted flare 45° SAE, but good luck finding a fitting to mate with it. i searched every auto and hydraulic hose shop in the tri-state area and couldn't find one. i ended up taking the stock hose and grinding the compression collar off the fitting and pulling the hose off. then just use that as a hose barb fitting and clamp your new hose onto it. a -6 AN hose will fit on the barb nicely. then you can use a regular an fitting on the other end to mate with whatever you're doing over there.
BTW - if you DO find a fitting that mates with the OEM, let me know where i can get one.
|
101822, RE: fuel line fitting question?
Posted by jack_of_trades, Nov-09-06 10:50 AM
Reviving an old thread rather than post more useless crap haha. Has ANYONE ever found the ACTUAL correct fittings anywhere? Its a never-ending quest lol. Someone has to make 'em.
|
101828, RE: fuel line fitting question?
Posted by Star Turbo Talon, Nov-09-06 04:45 PM
I made a female collar to run onto the fitting that would allow you to insert a 6an male union. THe two would join forming a seal.
There was word you could get such fitting but i never saw one.
Terry
|