How do i tighten the cord from throttle body to the gas pedal ? It came of tract so i put it back on but now its loose .

96 gs-t
Boost,and air fuel gauge
Borla Exhaust and muffler
shitty 16" rims

not installed:
97-99 conversion
Sensie front
invader skirts
invader rear
double deck aluiminum wing
m-3 mirrors w/ led
Front strut bar
coilovers
reverse indiglo gauges
Kenwood excelon in dash tv/dvd
10 disc changer

wanted:
6 bolt motor
18" rims


Remdawgz@aol.com

on your throttle body there s hould be a couple bolts that hold a slider down that is connected to your throttle cable, but i'm not sure if this is what your asking. if you move this piece of metal you can tighten it up a little, but you are adjusting your butterfly valve too.

on the intake manifold is where the two bolts are. there is a procedure on how to do it on this site under mods called throttle plate adjustment.

If these two bolts dont tighten it enough (as mine when I modded the TB) there is a black box lookin thing it comes out of on the passenger side of the engine bay. You loosen the front bolt and slide it off then loosen the back or tighten it, whichever goes the desired direction. Annoying work though because you have to fully put it back on in order to see if its tight enough then repeat that over and over. O well it worked

first thing I ever did too my car myself.......first thing I fucked up :) snapped one of the bolts by over torqueing it.....still need to fix that