Most of the time, if you buy your rods, they will always come with the appropriate bushings. But for some reason, if you need to pull your block after its been rebuilt and refit your internals with new wrist pins, pin retainers(locks), and rod bushings, you'll need to call up your rod manufacturer. In any case, I needed to since 3 of my Crower rods were used once before, and although they're in great condition, it's always recommended to get some new bushings for them. Rather than be on the phoen with Crower and rack up your phone bill figuring things out, I've already gone to the trouble for you.

Here's the Crower part numbers/spec:

Crower Bushings- Part # 90926 for 0.827" wrist pin (MAKE SURE AND SPECIFY TO SALESPERSON THE WIDTH WHICH IS 1.060)

thanks for the info bro

I feel a sticky or something is in order for this one....very useful info IMHO..