Combustion Chamber Cleaner, I've heard it works wonders. Thanks!!!!!

My friend, which is a chrysler tech, told me that it is basically carb cleaner, but works a little better. So I say go for it

I used 3/4 of a can when I did my headgasket
Lots of dark smoke the next morning

Alain

I use it all the time, it works well.

To use it properly, do it before an oil change.

Let the car idle for a couple minutes, then spray it directly into the throttle body. Don't rev it past 2000rpm, but make sure you can keep it idling while spraying it in. Once the entire can is injected, let it idle for a couple minutes then shut off the car. Let it sit for at least an hour. Start it up and go for a drive. You'll want to do it at night, since your car will smoke like crazy. Floor it a few times. Drive for at least 10-15 minutes. Go home, change the oil.

I usually use it 2 times a year.

I wanna do that this weekend, but

1. Where do you get it?
2. How much of it should I get (how many cans)?
3. How much does it cost?

#1: The Dealer
#2: One Can
#3: About $5

Mopar Combustion Chamber Cleaner, p/n 04318001

Thanks man.

might also want to change your spark plugs afterwards too (or at least clean them off). mine had all kinds of black goop on them after i did this!

Thanks!!!!!

I found a write-up that said to take out the plugs and dump 2 tablespoons into each cylinder, and let it sit over night. Anyone tried that?