Go back to previous topic
Forum namePerformance/Engine
Topic subjectchanging oil pump?!?!?
Topic URLhttps://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=31969
31969, changing oil pump?!?!?
Posted by ftk10198, Sep-05-02 12:32 PM
has anybody had any problem with the oil pump??? I think my oil pump has gone bad and might need to be replaced. Has anybody done this yet? if so, is it a hard thing to do? I think I need to change mine because some how I am losing oil pressure with a full level of oil. I also noticed that the brand new oil that I put in, turned very ugly with only less then 20 miles of driving on it. One of my friends even noticed some traces of very small aluminum flakes in the oil. Does any one know where this might be coming from? Any help is truely apprciated... :)

96RS
Intake/Exhaust; AEM Cams; Unorthodox Underdrive Crank Pulley; Breathers; Magnacor Wires w/ NGK Plugs; Powder coated valve cover; Chameleon Paint Job; Sensei front bumper; Andy's side and rear bumper; Combat wing; Front Projector Lights; Altezza Tail Lights w/ custom Reverse Strobe lights; 18" Concept 5 225-40-18; Ground Control Coil-overs; Matrix Front and Rear Strut bars; Custom Carbon fiber interior; Indaglo gauges; Auto meter Air/Fuel Ratio Gauge and Oil Pressure gauge; Push Button Start; and custom Stereo system.

ps. once I found out how to put my pictures in here, I will place them here. :D
31970, RE: changing oil pump?!?!?
Posted by DarkOne, Sep-05-02 01:06 PM
It's similar to doing the timing belt - that all has to come off, including the timing sprocket on the crank, for the oil pump to come off. Once all that's done, the oil pump is five bolts. it's like $90 from Howell, and it comes with a seal. The oil pan and oil pickup have to come off too.

You might just have a bad pickup o ring.
31971, RE: changing oil pump?!?!?
Posted by ftk10198, Sep-05-02 01:46 PM
where is this pick up o-ring located at???

96RS
Intake/Exhaust; AEM Cams; Unorthodox Underdrive Crank Pulley; Breathers; Magnacor Wires w/ NGK Plugs; Powder coated valve cover; Chameleon Paint Job; Sensei front bumper; Andy's side and rear bumper; Combat wing; Front Projector Lights; Altezza Tail Lights w/ custom Reverse Strobe lights; 18" Concept 5 225-40-18; Ground Control Coil-overs; Matrix Front and Rear Strut bars; Custom Carbon fiber interior; Indaglo gauges; Auto meter Air/Fuel Ratio Gauge and Oil Pressure gauge; Push Button Start; and custom Stereo system.

ps. once I found out how to put my pictures in here, I will place them here.

31972, RE: changing oil pump?!?!?
Posted by pn0ymahal, Sep-05-02 04:43 PM
how much better is the oil pump howell sells? its the melling kind.. i plan to do a rebuild soon, so i was debating on that, and just buying a stock one from mitsu since i can get a club dsm discount ...




Michael 99gs
HRC Stage 2
http://www.dreamwater.net/purplebeast