What should I get done? I want specifics. I know the belts, plugs, wires, water pump, cooling system flush, oil change. What else, if anything?? Thanks

Make sure you change the tensioner also. They are reusable, but I talked to enough people who say they have seen them fail and it is not worth the risk.

For your benefit, here are some part numbers:
M04667611 - Timing Belt
M04667283 - Tensioner

I will warn you that I paid $88.54 for that tension with a great discount. It lists for $139.46. But get it!

**********************************

"Don't worry, I'm fluent in weirdo."
Hurricane_GS
eclipse@gcni.net
AKA: Glenn H. Shelton III
Saint Cloud, FL
1997 Eclipse GS Non-Turbo
http://eclipse.greenliquid.com
---------------------
Front/Rear Upper Strut Bar
Neuspeed Front Strut Bar
Custom Lower Front/Rear Tie Bar
AEM Cold Air Intake
Pace Setter Muffler
Custom Short Shifter (Only $40 - Email me for info! eclipse@greenliquid.com)
Smoke Tinted Clear Tail Lights
Custom Illuminated Center Tail
Tokico Blues/Eibach Pro Kit

On the way:
Indiglo Needles

IS that all? i thought there was a whole lot more...dont we need to like clean fuel injectors and fuel filter too?¿


1999 Mitsubishi Eclipse GS 10th Anniversary OZ Edition
Check Out My Site For Pix
http://mywebpages.comcast.net/EclipseRaceR/Site/Page%201.htm

60k MUST do's:
Timing Belt
Tensioner pully
Idler pulley
Water pump
New power steering/Alternator belts

60k *should do's:
Tensioner
Camshaft oil seals
Crank oil seal
Alternator(might as well since its much easier to get at now)
Fuel filter if not done already

That's about it, and if you do all of the above, you should be good to go for a long,long time..

i have already done mine, but how wide is the timing belt. for some reason, mine looks kinda thin. let me know.
later

>i have already done mine, but how wide is the timing belt.
>for some reason, mine looks kinda thin. let me know.
>later

A good guess without measuring it, about 1 1/4" thick
It should go the full width of the cam gears..

fuel filter is actually listed as like a 10k service. I recently changed mine, and the stocker was CLOGGED! But now my gas mileage is worse. I guess it flows too good.

Thanks for all the info guys.

Where can I get these parts...like the tensioner and water pump and stuff like that?


1999 Mitsubishi Eclipse GS 10th Anniversary OZ Edition
Check Out My Site For Pix
http://mywebpages.comcast.net/EclipseRaceR/Site/Page%201.htm

do try to get them at satan, in fact go to a chrysler/dodge dealer first and ask for a quote for an Eagle Talon, then go to mitsubishi and ask for a quote for the same parts. and Download CAPS.

You can go to an autostore, but from my experience, they don't have everything at hand and they mess up with the orders, and you will probably get something for a 4g63 like me :rolleyes

NOTE: there are 2 pullys, one comes with a bracket, don't buy that one unless you need the bracket, just buy two idle pullys and put one in the bracket and the other where it should go.