Hi! My friend and I working on the automatic to 5 speed transmission swap right now.

We got most of the stuff done already, and we are ready to do the wiring stuff later today.

I know there are a lot of people in here had already done a 5 speed swap, can you please give me some advise on the wiring stuff? This would really really help me a lot. and make my life much easier. PLEASE!!

Basically can you please explain to me every thing about the wiring for the swap? Like the shifter plug wire, speedometer and the reverse backup light.

Please help me out!!

Some one please help me!!

I can't figure out where is the shift switch for the automatic and how it hoop up to the manual.

Any help would be appreciated. Thank you!!!

I have no idea. What you should have done is researched BEFORE you tried to do it. I think their have been a few successfull swaps by people on this board. Someone will answer.

I did tried to use the search the archive, but I having problem using it. After clicked search it will show blank screen.

I will search if someone please tell me how to use this search.

If any one could use the search archive can you please help me search and tell the links to those posts! PLEASE!

Thank you!!

archive search doesn't work

There is a good wiring write up on www.armond30.com at the bottom of the technical info section. As for the shift switch, I am not sure what you are asking?
-=B-=

Sorry, I mean the wires that you suppose to re-connect to make the car start after you change from auto to manual.

I got every thing done except for that. Which when I tried to crank the car it won't start.

Can someone please help me with this, I am so close to finish my transmission swap.

Thank you!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

I mean the starter wires to activate the starter circuit.

i wouldnt nkow but did you check the chiltons ?

Well, there is one wire in the transmission pickup switch that needs to be grounded for the car to start. This is the neutral/park position sensor. Tells the car if it is in neutral or park, as those are the only 2 positions that the car will start in. The wire that must be grounded is black with a yellow stripe. This can be used to wire up the clutch switch. Simply run that wire to one of the wires on the clutch switch harness, and the other wire from the harness to ground.
-=B-=

I finally figured out how to do the wiring stuff. Thanks to all the people that helped me out.

Thank you!!!

Cool. Now that you know how to do it you can help the rest of us with our swaps :-)

.

When you are done, a COMPLETE list of parts would be the best thing since the color blue. I've seen alot of list, but at the end it always says "and some other parts..." or something. Sorry to ask a favor when you need help, but since your doing it now I thought I might jump on it. :thumbsup