Where does the plate in the middle go? I know the one on the top goes on the back of the intake and the one on the bottom goes to the side of the head. So where does the middle piece in the picture go?

in da trash meng... i only used two thiings to block mines off, and they lookd similar to the part on thetop of that pic...

the bottom one might werk for u tho, but junk that middle one.

good luck

I used the same kit; don't need the middle one.



Eric Madden

Thanks, I thought that it wasn't needed.

Where can I order the egr blockoff kit at

You can get this kit from your neighborhood everyday Dodge dealer. Or you can go to the Chrysler dealer sown the street. They can all sell Mopar Performance. If you don't have a Talon, but have an Eclipse, tell them you have an Avenger or a Sebring 4 cylinder.
-=B-=

Why do you guys waste your time and money on buying the block off kits? Just pull the vacume hose from the EGR actuator to the EGR valve.

hey justone, i was wondering if you could tell me the part number for that little kit. it is sunday and im bored haha. but i bet the dealer parts stores are closed on sundays. hmm.

egr block off kit p/n is p5007276 fit 95-99 sohc and dohc 2.0L's

The middle block off plate is for the single overhead valve intake side of the egr tube. The blue seal goes into the intake and then the block off plate. Like everyone says... in the trash.
<---- has mopar performace catalog in front of him today (sunday) IM if you are bored and I'll rattle off more p/n's and we can b.s.
Doug

http://howell.mountain.net/Neon/Moparperformance.html

probably cheaper than the dealer.