| Go back to previous topic | | Forum name | Performance/Engine | | Topic subject | Crane Ignition which figure for install ? | | Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=20386 |
20386, Crane Ignition which figure for install ?
Posted by pn0ymahal, Apr-15-02 03:41 PM
i got the crane Hi-6Di2 with new tach adap and map sensor and retard control it looks sweet...hehe which figure do i follow for install?would it be figure 4 page 7? and if i where to install the rest figure 7 page 11? also for the optional map sensor which i got i just got to put a vacuum hose from there to the manifold correct? does it matter if its to another T which leads to the manifold or does it got to be direct?
Michael 99gs
Boost It!
Mods:
no time to put in yet:315cc injectors, & crane ignition.
Hrc Stage 2
S-FMU
Greddy Type S Bov
VC-2
Road Race Catch Can
Greddy Profec B & Switch
Apexi WS Catback
Super Afc
Autometer Boost,
Egt,Tranny Temp Gauge & Cooler
Air/Fuel Light & Digital
Tokico Adjust Struts
Eibach Pro Kit Springs
Front & Rear Upper Bar
CarCraft Interior
Sound System= Bring it On
|
20387, RE: Crane Ignition which figure for install ?
Posted by Michael_97RS, Apr-16-02 01:43 AM
Use "Figure 5. Generic Hook Up For Four Tower Coil Pack" figures 1-4 are for the 4G63.
Una salus victus.
It's not about being invincible, it's about being ready; for anything.
Michael J. Kulaga
e-mail: Michael_97RS@2gntDSM.zzn.com aol IM: MJKulga
http://highlander.dsmpower.com/
Injen CAI, 55mm TB, Hooker 4-1 Stepped Header, GS-T Muffler, AFX UDP, S-AFC, 8.5mm Magnecor Wires, Crane Fireball HI-6DI2, SS Clutch Line, NRG Susp. Motor Mount Ins., FU/RU/RL STBs, TSW Blade 17x7.5, Bridgestone Potenza RE730 215/45ZR-17. Front KVR Cross-Drilled Rotors & Carbon Fiber Pads
To Be Installed: P&P Intake Manifold 1/2, P&P Milled Head, Rear Disc Brakes, Rear KVR Cross Drilled Rotors & Carbon Fiber Kevlar Pads, SS Brake Lines
| |