| Go back to previous topic | | Forum name | Performance/Engine | | Topic subject | Cam Gears | | Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=1514 |
1514, Cam Gears
Posted by dudasd, May-04-01 04:27 PM
I have a 96 RS and was wondering if anyone could give me a good guess as to where to set my cam gears when I get them in next week. I travel alot so finding time to do the guesswork is few and far between. Any pointers as to a good setting would be greatly appreciated.
|
1515, RE: Cam Gears
Posted by Talon, May-04-01 05:09 PM
+2 intake -2 exhaust
Talon
97'Talon Esi
Smokin' Honduh's All Day Long!
|
1516, RE: Cam Gears
Posted by dudasd, May-05-01 03:19 AM
Talon,
Thx for the reply. I did some searching on here and that seems to be the "almighty" setting for stock cams. Thx again...
|
1517, RE: Cam Gears
Posted by Talon, May-05-01 05:12 AM
np thats what we are here for. you are runnin stock cams right? i just had my AEM gears installed and havent set them so i dont know about performance. i want to know how much HP i should gain with added compression ????
Talon
97'Talon Esi
Smokin' Honduh's All Day Long!
|
1518, RE: Cam Gears
Posted by dudasd, May-05-01 10:07 AM
Not sure. I did a search last night after I posted on the subject and nobody mentioned if they had stock cams, but the general consensus seems to be with the specs you gave me around 5 HP of a jump. I'm just waiting for them to get in and then I can get a new timing belt too. I know of a dyno close by, so I might go ahead and get it done before and after and let you know what the outcome is if I have time. Only other mods I have are CAI and Pace Setter cat back. Looking into a MSD Dis-2 next. I was gonna go with a new header, but from what I have read on here, nobody is getting much of a gain out of them so I think I can wait for the time being on that note. I was looking at either the HKS or getting a custom grind for the cams, not sure which I want yet, any ideas????
|
1519, RE: Cam Gears
Posted by Michael_97RS, May-06-01 04:09 AM
Wait for the Crane Cams to some out for us. New grinds not regrinds.
"To strive to seek to find... and not to yield."
Michael J. Kulaga e-mail: Michael_97RS@2gntDSM.zzn.com
aol IM: MJKulga Website: http://highlander.dsmpower.com/
Injen CAI w/ K&N Breather Filters, 55mm TB, GS-T Muffler, FU/RU/RL STBs, Front NRG Susp. Motor Mount Ins., Red Silicone Hose Kit, 8.5mm Magnecor Wires, Bosch Rapidfire Plugs
And in my Room: Rear disc brake conversion kit, SS Brake Lines, Intake manifold 4 porting, Rear Motor Mount Ins. RRE FL Tie Bar(Well Almost), TSW Blade 17x7.5 (need tires)
| |