Hello everyone,

This is my first post in a while and I'm pretty much done with the rebuild process. Everything checks out great with clearances, everything torqued in sequence, the whole nine. The rebuild wiki is amazingly helpful in this process.

While scrolling through the wiki pages I came across the 4g63 injector and fuel rail mod. Assuming this is a wiki, it seems very viable to pursue this route to finish off my engine. Any suggestions on if i should follow this path or follow another?

Thank you,

Stefan

Why are you wanting to use a 4g63 rail? Are you missing yours? The factory rail is fine and can support plenty of power in its current form.

well I was just looking through the wikis for information on the fuel set-up. I came across that and figured I would ask about it. I do have the stock fuel rails and everything which I am going to you. Just trying to figure out what CC injectors to get. The equation is a tad bit hard to plug the variables into. My friend is helping me with that as well.