I am going to describe this the best I possibly can. I have just replaced the vavle cover gasket, making sure it stayed seated in the valve cover while putting it down, and making sure to not over tighten the bolts. But on the driver side of the head, the back cam there is a lip on the head which I can see oil puddling up there and I can smell it sometimes. Is there a seal I missed or did the gasket not seal right? Any help or information would be greatly appreciated.

Did you rtv all the correct locations?

With it being a rubber gasket I didnt think that it would need rtv anywhere. Where is it supposed to have some?

Yes, check a shop manual for the correct location

You are describing the aluminum half moon. There are specified points, as mentioned, that small amount of RTV is required. Consult manual.

Exactly what Dave said. I took the aluminum half moon out and resealed the whole thing because it was leaking from there.

Review this and you'll be on your way again.

http://www.2gnt.com/index.php?d=Replacing_valve_cover_and_spark_plug_gaskets

Thank you for that link, I guess I should have not assumed that it did not need any.