Hello everyone. This is my first time posting on this forum so i hope you can all help. I am finally done with the engine build of my 420a motor. have forged rods, pistons, 8.8:1 compression with .020 overbore. bearings and everythign fits properly. next is setting up megasquirt. where would i buy it? Looking for MS 2.0 or better and is there a guide to install? also what cc injectors should i be getting. if anyone needs more info to help with my questions just let me know.

Read the wiki on the main page to answer your megasquirt questions. You can buy kits from DIYAUTOTUNE or assembled ones from SymTech - look at the banner advertisements.

again check the wiki as there are install articles.

went and checked the article it is deffinatly what im looking for also consulting my friend who has installed MS in his Saturn SL. check the sites for the kits they are a tad bit pricey but did expect that, also what type of injectors should i be shooting for?

Depends on your target horsepower level. Google "injector calculator" and use that.

Its not too hard buy a kit and solder it togather if you want to save a few dollars....


Id assemble a jimstim/megastim first if its your first time soldering before you move on to a MS unit.