One of my lines right next to the slave is leaking. Instead of buying a new one, I figured i could do stainless steel and make it look better and perform better. I was curious what size stainless steel hose i need (4an??) and what about fittings at each end? Could someone help me out here, opinions would be amazing.

Pick one up from road race engineering.

I can't seem to find the complete set from the master to slave cylinder. I can only find the one that replaces the rubber part.

Originally posted by xxsoccerguy55xx
I can't seem to find the complete set from the master to slave cylinder. I can only find the one that replaces the rubber part.

There probably isn't a complete set for what you're asking for. You're gonna need somewhere around 8' of line maybe more depending on how you want to route it.

I'd say its going to be more of a PITA to do for the results you are expecting. Not worth it. Get a line from RRE that replaces the rubber part as CODE4 said above.

Also, properly bleeding the slave/line will help firm things up as well.

The other half of the line is hard line why do you need to replace it anyways.

The SS clutch line for the 4g63 GST model wont fit on the 420a right? im not totally sure.

i have a little leak.