As part of my cars long build sheet, and power aspirations I have gone ahead and designed and fabricated my own 8an fuel rail.

Details:

I designed this rail to work in conjunction with the O.E. Intake Plenum, It utilizes the factory provisions for both hold down and Injector O ring Style. In other words, it's a direct bolt in piece.

Bore Diameter: 12.7mm - I purchased a special drill bit to complete the boring process in one function not two like most machine shops which results in a clean straight no "step" or offset bore.

Material Type: T6061-T6 Aluminum Billet rectangle stock, edges have been radii for a clean appearance, however pictures do not depict how final appearance may look.

Fitting Type: AN to Metric thread: M16*1.5 O ring type








If you are interested in obtaining a unit for yourself please contact me personally via PM. Please leave the thread for technical questions, comments and criticisms only.

Yes please! Looks awesome!

Are you doing this for "bling" factor? I understand if that's the case, but simply altering the stock rail with fittings should give you the same effect. Once you open up the end of the rail on a stocker, you have plenty of "chamber" inside for fuel.

Def not for a "bling" factor. If that were the case I would have chosen and designed a better looking bar stock. I did this for a few reasons; (1) I have purchased 2 fuel rails from undisclosed sources to which utilized NTP ends, that no matter what or who tightened the fittings and weather or not I used aluminum, or steel, natural or finished fittings would always end up leaking on me. (2) Provides me with a free(er) flowing system from pump to rail, being all 1/2" ID stuff.