Go back to previous topic
Forum namePerformance/Engine
Topic subjectcrankshaft sprocket
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=5&topic_id=132431
132431, crankshaft sprocket
Posted by sheldon, Dec-31-69 06:00 PM
Is it necessary to remove the woodruff key to remove the sprocket? If so, how do you get it out?
132432, RE: crankshaft sprocket
Posted by 420agreenvilleSC, Dec-31-69 06:00 PM
IIRC, no.

but if you have to get the key off, take a flat head screw driver and lightly hammer it towards the sprocket. it's in a tight groove and will loosen out of it after a few taps
132435, RE: crankshaft sprocket
Posted by dougie2, Dec-31-69 06:00 PM
You can't remove the key while it's still under the sprocket.
132436, RE: crankshaft sprocket
Posted by sheldon, Dec-31-69 06:00 PM
Thanks guys. I may attempt to remove it today. Need to replace the seal in the oil pump.
132438, RE: crankshaft sprocket
Posted by CODE4, Dec-31-69 06:00 PM
Originally posted by 420agreenvilleSC
IIRC, no. but if you have to get the key off, take a flat head screw driver and lightly hammer it towards the sprocket. it's in a tight groove and will loosen out of it after a few taps


The gear must be removed for the key to be removed otherwise it would defeat the purpose of the system.
132439, RE: crankshaft sprocket
Posted by 420agreenvilleSC, Dec-31-69 06:00 PM
Ohhhhh I know what ya'll are talking about. I was thinking of the crank key further out oh the snout. Nevermind.
132441, RE: crankshaft sprocket
Posted by CODE4, Dec-31-69 06:00 PM
As far as I know there is only one woodruff key. What other one are you thinking off?
132442, RE: crankshaft sprocket
Posted by bullettdsm, Dec-31-69 06:00 PM
Originally posted by 420agreenvilleSC
Ohhhhh I know what ya'll are talking about. I was thinking of the crank key further out oh the snout. Nevermind.

Originally posted by CODE4
As far as I know there is only one woodruff key.

Been drinking the Thanksgiving eggnog there Mikey?

132444, RE: crankshaft sprocket
Posted by 420agreenvilleSC, Dec-31-69 06:00 PM
Originally posted by bullettdsm
Originally posted by 420agreenvilleSC Ohhhhh I know what ya'll are talking about. I was thinking of the crank key further out oh the snout. Nevermind.
Originally posted by CODE4 As far as I know there is only one woodruff key.
Been drinking the Thanksgiving eggnog there Mikey?


LOLL nooo.. not yet at least. Anywayz, no, there's a" key" that u align the crank sprocket on, then there's one further out than that. I might be crazy but I need to get a pic and share. I might be confusing it w/ the 2.4 crank
132445, RE: crankshaft sprocket
Posted by CODE4, Dec-31-69 06:00 PM
Negative ghostrider. 2.4 crank is the same except it is a little longer to account for balance shaft sprocket.
132446, RE: crankshaft sprocket
Posted by 420agreenvilleSC, Dec-31-69 06:00 PM
ok now i'm curious what i'm smokin if i'm wrong. next time i'm at tim's, i'm takin a pic
132449, RE: crankshaft sprocket
Posted by CODE4, Dec-31-69 06:00 PM
132450, RE: crankshaft sprocket
Posted by teklein, Dec-31-69 06:00 PM
Ummm, how did I get into this?

There is only ONE key...
132452, RE: crankshaft sprocket
Posted by 420agreenvilleSC, Dec-31-69 06:00 PM
nice pic dave. yea, ur right. dunno y i thought there were two. egg nog got to me
I generated this page in 0.010699987411499 seconds, executing 7 queries.