Hello forum,
Here are a few codes I'm getting from my eclipse 95 gs.
P0505 Idle control system Malfunction
P0108 Map/Baro Circuit High Input
P1297 Manfacurer Control Fuel Air Metering
P0351 Ignition Coil Primary/ Secondary Circuit Malfunction
P0412 Sec. Air Injection System Valve Malfunction
P0113 IAT Sensor 1 Circuit High Input

the P0412 I know about, I think Manfacurer should be Manufacture.
Any help on what to fix would be appreciated since my budget is low right now and the car is not running well.

Specially on the P0351, I'm not sure if i must change the coil or it's the harness towards the coil is the trouble. but I'm going to check up on that today

I have already been at http://www.2gnt.com/index.php?d=PCM%20Error%20Codes

I'm just looking for opinions from you people

Did you check the harness that runs along the EGR tube?

Yes, found the problem, there was no screws on the EGR pipe on the intake side, they must of loosen and fell down somehow. Now the Coil Pr/Snd Circuit and the sec air intake remains. I think i must try with a new coil, but i will continue check on the harness