| Go back to previous topic |
| Forum name | Performance/Engine |
| Topic subject | Intake Runner Bolt / Stud Locations? |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=128512 |
128512, Intake Runner Bolt / Stud Locations?
Posted by 95_ESi_Person, Nov-01-09 05:14 PM
I'm going to try to save some time and aggrivation by putting the runners back on the head before re-installing the head on my car, but I cannot for the life of me remember where all of the studs go.
I do remember this (head's intake side facing me):
-2 bolts top center
-1 extended thread bolt (stud with a frozen nut) bottom right (got the bolt and wrench stuck in the alternator bracket until head was removed)..
- Can not remember the rest...
Anybody know or have a picture?
|
128513, RE: Intake Runner Bolt / Stud Locations?
Posted by 420agreenvilleSC, Nov-01-09 05:22 PM
IIRC, studs don't matter, but if it does, it were to hold the rear engine lift bracket on. I really don't think it matters.
|
128514, RE: Intake Runner Bolt / Stud Locations?
Posted by CODE4, Nov-01-09 05:30 PM
Agreed... the bracket is on the front of the motor, towards the alternator as you know. The rest do not really matter. I am running ARP SS studs on all locations on my setup now.
http://zero-signal.org/2.4L/2.4-install-2.jp g <-- add the damn g to the link and it will open.
|
128515, RE: Intake Runner Bolt / Stud Locations?
Posted by 420agreenvilleSC, Nov-01-09 05:45 PM
that's specifically for you mike
|
128516, RE: Intake Runner Bolt / Stud Locations?
Posted by 95_ESi_Person, Nov-01-09 05:55 PM
sounds good to me. the support brackets are located mid-runner anyway,that will pose no problem.
|
128517, RE: Intake Runner Bolt / Stud Locations?
Posted by dsmracr420a, Nov-01-09 09:18 PM
The support brackets are not necessary either.
|