I've noticed that there's quite a bit of slack in my throttle cable, I'd like the remove some of that, is this possible? I ask because sometimes if I've got the muzak-a-blastin' and I can barely hear the engine, I end up not giving it enough juice and it will stutter a bit.

Coo'
1997 RS
AEM Cold Air Intake
Trust Shift Knob
Trust EVO Exhaust
AutoMeter A/F Ratio Gauge
'tis it

Tup the exact procedue is under 2gnt.com in the Mods section. You basically just loosen those two 10mm bolts, and slide that plate over.

eclipse804@hotmail.com
http://importdeals.homestead.com
Import Parts and Performance

I don't remember how the mod is written up but I think there is a lot of little adjustments they suggest.

I have a better way to adjust the throttle plate. If you have a friend, loosen the bolts and have him put the pedal all the way down and then slide the plate back as far as it will go and tighten down. I used a long block of wood and wedged the pedal down. I had the intake off and mine had no problems coming completely closed.

"To strive to seek to find... and not to yield."
Michael J. Kulaga e-mail: Michael_97RS@2gntDSM.zzn.com
aol IM: MJKulga Website: http://highlander.dsmpower.com/

Injen CAI w/ K&N Breather filters, 55mm TB, FU/RU/RL STBs, Red silicone hose kit, 8.5mm Magnecor Wires, Bosch Rapidfire Plugs

And in my Room: Rear disc brake conversion kit, SS Brake Lines, GS-T Muffler, Intake manifold 4 porting, Energy Suspension Motor Mount Inserts. RRE FL Tie Bar, TSW Blade 17x7.5 (need tires)