Go back to previous topic
Forum namePerformance/Engine
Topic subjectsmoke after waterpump installation
Topic URLhttps://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=121735
121735, smoke after waterpump installation
Posted by bokchoi, Jul-14-06 06:05 PM
Welp, right after the waterpump installation and pouring the coolant back in I tried running my car. And everything seemed fine while I was driving; the temperature needle was slightly below the middle. However, lots of smoke began to come out of my exhaust with a strong smell of the coolant...is that suppose to happen with a new waterpump? I didnt continue driving but I will test it out again tomorrow morning. But I wanted to make sure I didnt do anything wrong. Is the smoke suppose to be a normal occurence just to warm it up?
121736, RE: smoke after waterpump installation
Posted by azdave, Jul-15-06 02:15 AM
There is no reason to expect any kind of smoke after a water pump change or timing belt change. It should come back to life just as it was before the repairs (other than "burping" some air out of the cooling system when you first start it up).
121737, RE: smoke after waterpump installation
Posted by aivanne182, Jul-15-06 04:18 AM
just to calrify something....smoke is coming from the exhaust somewhere under the hood or at the tailpipe ?
121738, RE: smoke after waterpump installation
Posted by xcasbonx, Jul-17-06 01:42 AM
Assuming you installed the gasket correctly, and torqued the bolts down evenly to spec, everything should be good.



http://www.dsmregistry.com/detail.php?carid=1185
121739, RE: smoke after waterpump installation
Posted by aivanne182, Jul-17-06 05:44 AM
my guess is on the gasket....coolant leaks on the block and creates smoke.