So I finally got my car running after the rebuild and turbo installed. I ran it for two days and then i parked it in my driveway. I went back out to the car to go to work and i notice a leak on the ground.

So i started the car and watched to see where it was coming from and sure enough it was the oil pan.

Well, it was anitfreeze that was leaking out from the oil pan, and oil filter.

So my question is it the head gasket or something else. Could it be the bed plate?
I need help fast.

Thanks

Maybe the holes in the headgasket weren't properly aligned;
just thinking out loud.

Can Anyone Help Out Any More Than This?

It's the headgasket, or a crack in the block. Do a compression test.

Originally posted by DarkOne
It's the headgasket, or a crack in the block. Do a compression test.

Ditto.

Originally posted by dougie2

Originally posted by DarkOne It's the headgasket, or a crack in the block. Do a compression test.

Ditto.

same crap happened to me 4 days ago = head gasket gone

good luck

Is coolant actually IN the oil pan or is it just dripping off the outside of the pan near the filter?
IF its just dripping near the filter, it is possible that the water pump gasket/ring isn't seated right and leaking slightly. It will trail along the block and drip down around the oil pan/filter....don't ask me how I know. :(

Originally posted by lgjhn
Is coolant actually IN the oil pan or is it just dripping off the outside of the pan near the filter? IF its just dripping near the filter, it is possible that the water pump gasket/ring isn't seated right and leaking slightly. It will trail along the block and drip down around the oil pan/filter....don't ask me how I know. :(

I agree. Why would coolant be dripping out of the filter and pan, and not oil. I'm betting on it leaking from a hose or the water pump, as stated above. Do some more searching.