| Go back to previous topic |
| Forum name | Performance/Engine |
| Topic subject | How to replace and wire a crankshaft pos sensor plug?. |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=119939 |
119939, How to replace and wire a crankshaft pos sensor plug?.
Posted by kinkopy, Feb-22-07 05:00 AM
I went to change the crank pos sensor and it broke off in the engine so i drilled it out and baught a new one but the new one had a different plug on it i was confused then i went to everyone around looking for a different sensor yesterday and everyone had the same thing. Turns out to be that they had a recall on the plug that plugs into the factory sensor ;[ So i got to the dealer and they sell me a plug with a bunch of wires in it extras im guessing cause its a 3 wire plug but to use this plug i have to cut off the old one and crimp in the new one . Came with a couple heat shrink wrap tubes too. the thing is all the wires they gave me are all the same color and i dont know what matches up to the factory wires and i cant find a diagram for it anywhere ;[[[
|
119940, RE: How to replace and wire a crankshaft pos sensor plug?.
Posted by nyBoosted420a, Feb-22-07 07:35 AM
what year is your car
|
119941, RE: How to replace and wire a crankshaft pos sensor plug?.
Posted by thedawg, Feb-22-07 10:13 AM
First, get the right sensor. If Satan can't handle that, Autozone can.
http://www.2gnt.com/pnc.php?op=display&pnc=14932
Pins, from left to right, with orienting tab at top, looking towards the sensor, for 97-99's:
1 - Yellow wire - to male pin 3 on MFI harness, to pin 10 on ECU harness A83
2 - Black wire/Green stripe - to male pin 2 on MFI harness, to pin 7 on ECU Harness A82
3 - Blue wire/White stripe - to male pin 1 on MFI harness, to pin 23 on ECU harness A83
MFI harness is 10-pin intermediate connector between sensors and ECU, and is located under throttle body.
Data from circuit diagram 122.
|
119942, RE: How to replace and wire a crankshaft pos sensor plug?.
Posted by kinkopy, Feb-22-07 11:21 AM
yeah its a 96 so it should be the same .. I hooked it up how you described and im still not getting any fire to my spark plug cables and i also changed the relays on the firewall and change the camshaft sensor ;<[br />
|
119943, RE: How to replace and wire a crankshaft pos sensor plug?.
Posted by thedawg, Feb-22-07 11:27 AM
Maybe you hooked it up backwards. Try swapping pin 1 and 3.
Also, if you follow the link in my previous post, you will see that 96 is in fact not the same as 97+.
|
119944, RE: How to replace and wire a crankshaft pos sensor plug?.
Posted by kinkopy, Feb-23-07 06:07 AM
So whats the right way to hook it up for a 1996 just swap the wires?
|
119945, RE: How to replace and wire a crankshaft pos sensor plug?.
Posted by thedawg, Feb-23-07 06:41 AM
1) Get a 96 sensor to plug into your 96 harness.
2) Get a 96 electrical schematic if this is still confusing.
|
119946, RE: How to replace and wire a crankshaft pos sensor plug?.
Posted by kinkopy, Feb-23-07 10:27 AM
I got it i didnt have it wired right <;[br />
|