| Go back to previous topic |
| Forum name | Performance/Engine |
| Topic subject | H2O temp gauge and oil pressure guage install help |
| Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=5&topic_id=117250 |
117250, H2O temp gauge and oil pressure guage install help
Posted by mike, Dec-31-69 06:00 PM
Just got for x-mass an AM water temp and oil pressure gauge for my 98 eclipse rs. These guages are going to be mounted in an A-pillar mount. Was looking for help and some tips if anyone has installed any one of these gauges. Or somewhere else that I could check out for instructions on instalation. Any help or tips would be greatly appreciated. Thanks, my e-mail is eclipse_rs@excite.com
Mike
|
117251, RE: H2O temp gauge and oil pressure guage install help
Posted by Michael_97RS, Dec-31-69 06:00 PM
I've done the opil pressure install. You need a t-fittings and I would get a small extension to pull the T away from the block not a lot of rooom to work back there. You'll need I think it's 5/8" t-fitting 5/8" - 1/2" or so extension fitting, 5/8" to 3/8" adapter to put the oil ressure guage into the T. You'll be doing a lot of it by feel... the stock oil sending unit is on the back of the motor tranmission side. If you haev any questions about my ramblings let me know.
"To strive to seek to find... and not to yield."
Michael J. Kulaga
Michael_97RS@2gntDSM.zzn.com
aol IM: MJKulga
http://highlander.dsmpower.com/
|
127377, RE: H2O temp gauge and oil pressure guage install help
Posted by 420agreenvilleSC, Dec-31-69 06:00 PM
bump. lmao
|
127382, RE: H2O temp gauge and oil pressure guage install help
Posted by teklein, Dec-31-69 06:00 PM
Originally posted by 420agreenvilleSC
bump. lmao
Why?
Locking before everyone else comments on it too.
|