| Go back to previous topic |
| Forum name | Performance/Engine |
| Topic subject | Turning on power; a few questions. |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=115642 |
115642, Turning on power; a few questions.
Posted by msl-man, May-10-08 02:15 PM
I just finished pulling all the wire for my gauges, wideband, boost controller, etc., and put the finishing touches on my fuel system. I haven't hardwired any of them to 12v power yet. My question is this, can I plug the battery in and turn the key one click to test out my 12v switched sources so I can know where to wire everything? I am not going to cycle the engine obviously but I also do need to cycle the fuel pump and drain the old fuel out of the tank into a bucket. Is this a safe thing to do? I do see any issues with it as long as I don't cycle the engine but I thought I'd ask the pros. The intercooler piping isn't installed and the tranny has no fluid. Thanks in advance!
|
115643, RE: Turning on power; a few questions.
Posted by djtrickee, May-10-08 02:59 PM
As long as everything is fused properly I don't see any harm with it. If you are really concerned pull the ASD relay and the ECU harnesses but thats overkill really.
|
115644, RE: Turning on power; a few questions.
Posted by DarkOne, May-13-08 02:50 AM
Originally posted by djtrickee
As long as everything is fused properly I don't see any harm with it. If you are really concerned pull the ASD relay and the ECU harnesses but thats overkill really.
QFT.
|