so just the other day my car starts stalling while coming to stops.. then it starts sputtering and stalling while driving... sound like an idle air control valve???

Sounds like it!

Pull the sensor and ohm it out to see how it does.

Double check in the wiki or in the Haynes, but 53 ohms (ish) is where it should be IIRC :)

pretty sure that is the problem as well, at least that is what mine was doing and I just replaced it. I read that you can test the IAC by pulling it off and while still connect turn the car to the on position and it should do whatever it does.. But when I did this, i litteraly put a whole in my garage wall.needless to say, i had to replace it because the threading was stripped out since the piece was in impaled into my wall. Thank god no one was holding onto it. I have only done that once so I am not sure if that is one of the offical ways to test it.

so tested the iac and it was fine. i took a good look at my speaker wires and found one that was pinched and was contacting the chasis... fixed that and bingo, no more stalling! thanx for the replies

Hell yeah man!

Sometimes its things that arent even remotely related :)