| Go back to previous topic |
| Forum name | Performance/Engine |
| Topic subject | my idle is screwed up (already chkd idle screw) |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=11256 |
11256, my idle is screwed up (already chkd idle screw) Posted by LilRed1G, Jan-03-02 02:50 AM
i have a 90 talon tsi awd it is idling really bad not all the time. i checked the idle screw and it is there. changed plugs and wires. please help this is my daily driver and this is really annoying my car keeps dying on the way to work. any help is mucho appreciated
|
11257, RE: my idle is screwed up (already chkd idle screw) Posted by Kiku, Jan-03-02 03:00 AM
check your map sensor. may be not functioning properly.
My map sensor was bad and gave me erratic idling and stalling at idle, as well as fuel cut at 4k rpm.
|
11258, RE: my idle is screwed up (already chkd idle screw) Posted by LilRed1G, Jan-03-02 03:09 AM
where is it and how do i check it?
|
11259, RE: my idle is screwed up (already chkd idle screw) Posted by evan2, Jan-03-02 03:18 AM
see keith look at that took 10 mins for u to get a answer.. could be could not be.. but i was right yeaaaa
|
11260, RE: my idle is screwed up (already chkd idle screw) Posted by Kiku, Jan-03-02 03:39 AM
Its hard to explain but i'll try. Locate where your throttle body is. Now...go to the passenger's side of the intake manifold, and it is a small black sensor that is bolted to the intake manifold.
Get a voltometer and measure the voltage between the yellow wire i believe and ground wire (black wire). There are three wires going into the map sensor harness.
Turn your key to the ON position...dont turn your car on yet. and see what voltage you get. You should get very littel voltage. If it reads 4.79 or higher immediately, then its bad.
Then turn your car on and leave at idle. Your voltage should again not be close to 4.79
|
11261, RE: my idle is screwed up (already chkd idle screw) Posted by DarkOne, Jan-03-02 03:46 AM
He's got a 4G63, Kiku. His MAP sensor isn't quite as important as ours.. just a reference signal.
Things you may want to check: Adjustment on your BISS The honeycombs in your MAS Look for boost leaks Check the dumptube for your BOV.. is it connected or leaking?
...and this would probably be better in the 1g/4G63 section :-)
|
11262, RE: my idle is screwed up (already chkd idle screw) Posted by Kiku, Jan-03-02 04:04 AM
DOH! got me fooled! =)
|
11263, RE: my idle is screwed up (already chkd idle screw) Posted by LilRed1G, Jan-03-02 04:24 AM
thanks for the help guys i'll give it a try
|
11264, RE: my idle is screwed up (already chkd idle screw) Posted by drbalazo7, Jan-03-02 01:55 PM
I just had kinda the same problem on mine. I found out it was my MAS cause the dataloger kept reading it at 2.0. Try tapping the top of your MAS and if the idles gets even rougher, its for sure to be your MAS. hiope it helps

|