I need an 02 sensor for the front.
I bought one from Autozone and the harness didn't hook up together,
Is there any other kind that I can get that will match up besides the one from the dealer???

Or should I go back and get the Bosh one I took back and try to hard wire??
How hard would it be and how??

The wire colors should match up, so you could just get some crimp connectors, and splice it together. You also should use heat shrink tubing to go over the connectors. Check out http://www.ngksparkplugs.com and they have some instructions on splicing the o2 sensor wires. BTW, NOPI has the NTK o2 sensors for 37 bucks plus shipping. That's where I got mine. It's a four wire sensor.

I have a Bosch O2 sensor.. there is no harness for it. It's a 4 wire replacement, and you have to splice it in to your existing harness. Grey to grey, black to black, and white to white.. there are two white, but the polarity doesn't matter. They are just heater wires.. A little tape, you're good to go. And it's only about $70.

do what eclipse804 said. go to nopi and get it.. 45 bucks after shipping.. and got here in 3 days.. well im in fl.. so im close to GA.. but it clipped right in..

autozone wanted hella cash for it..

I live in Atlanta Ga.
They clipped right in and were only 45 bucks huh?
Well that sucks cause Nopi is down the street and i just paid 70 bones at auto zone for bosch

For the record, mine didn't clip right in, I had to splice it. I think Super20G's also did not clip in. It seems that people that ordered a while ago got direct clip-ins, but recently they've been sending out universal o2 sensors that require splicing.

well i got mine a month ago.. did you get the nkt (or ntk) in a gray box.. mne clipped right in. was a pain since my header was all hot. getting the thing to unclip hhaha... but i didnt have to splice at all..

all i have to say is huh? black to black, white to white, huh? My factory harness had liek all black wires with diff colors on them... deffinately not the same colors and the ones that come out of the other side of the harness to the o2 sensor... wasnt hard to match em up and know whats what, but dont put power to the heater wire :-) that was not a good idea unless you like wasting 46 bucks :-) whoops :-)

Just email me your address.. I have an extra one WITH the harness.