my pulleys are squealin like a bitch how do you stop them from makin so much noise when it's cold?

metal will shrink when cold. tighten up the belts, check to make sure they are not cracking and this should help.

"The fastest draw is when the sword never leaves the scabbard,
The strongest way to block, is never to provoke a blow,
And the cleanest cut is the one withheld."

Michael J. Kulaga
e-mail: Michael_97RS@2gntDSM.zzn.com aol IM: MJKulga
http://highlander.dsmpower.com/

All Motor Beast in the Making

Injen CAI, 55mm TB, Hooker 4-1 Stepped Header, GS-T Muffler, AFX UDP, S-AFC, 8.5mm Magnecor Wires, SS Clutch Line, NRG Susp. Motor Mount Ins., FU/RU/RL STBs, TSW Blade 17x7.5, Bridgestone Potenza RE730 215/45ZR-17. Front KVR Cross-Drilled Rotors and Carbon Fiber Pads

To Be Installed: Ported/Polished Intake Manifold, Rear disc brake conversion kit, SS Brake Lines, Rear KVR Cross Drilled Rotors and KVR Carbon Fiber Kevlar Pads

cool thanks

Since you don't have an u/d pulley, then I'd check to make sure the belt is tight (as stated in the previous post), and you could also spray on a little bit of belt dressing.

Mine belts squeaked since i got my car (last feb.) I tried everything....tightened them,loosened them, took them off and put them back on, cleaned them.........finally i took it to a mechanic and he put belt dressing on it, only to make it worse.....which i had already tried that too.......finally he just too the belt off and put a new one on. After he looked at the belt he said that it looked fine to him.....soo i still havent figured out what the heck it was.

I've seen alot of posts recently about sqeaking belts. The fastest sure-fire way to stop those belts from sqeekin is a little WD-40. A couple little spurts of that will stop any belt in your car from squeekin quaranteed or your money back! :)

-Tony 98'GST



http://eclipzgst.dyndns.org
AIM: turboclipz or YNOT420247