ive ran into a bit of a hitch with my jeep TB install. seems that i made the dumb mistake of trying to use the 2gnt IAC to control the idle on my car... so i realized i had to use the jeep IAC, but i didnt have one. so i ordered one from satan (for a 98 cherokee) and the connector for the sensor is different. so i need a PN for the correct sensor that would have the same connector as the 2g. or failing that, how to get the pintles off of these sensors, since i have a 2gnt IAC sitting here. i tried twisting and pulling and the dumb pintle wont come off like metaljim says it does. suggestions? help? should i just put some dynamite in the mani and light it? thanks guys

it'll twist off. but you can just get one for a 94 cherokee with 4.0L engine. the plug is clock differently but will bolt right up and use the existing plug

wonder if my chick will miss her tb on her jeep so I can do this.

Originally posted by goalie40
wonder if my chick will miss her tb on her jeep so I can do this.

Just take the radio too and tell her it got broken into :shrug

ok thanks for the help. i got it figured out and after fixing a minor vacuum leak, i took her for a spin, and i must say i was really impressed at the way the car ran. it was my car...but different..definitly a recommended mod!