| Go back to previous topic |
| Forum name | Performance/Engine |
| Topic subject | socket size? |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=103690 |
103690, socket size?
Posted by xceler8, Apr-01-07 04:22 PM
Quick question, I have about 500 miles on the new motor now with only one problem. I didn't torque down the threaded stud that the oil filter screws to. What size deep socket do I need for this?
Thanks
|
103691, RE: socket size?
Posted by eclipse982nrRST, Apr-02-07 01:45 AM
If I recal, its 1" or 1-1/4"
|
103692, RE: socket size?
Posted by talon749, Apr-02-07 04:47 AM
its like 23mm I just took that off yesterday
|
103695, RE: socket size?
Posted by xceler8, Apr-02-07 01:12 PM
I would hate to buy the wrong one now, anyone know for sure what size it is? 23 mm sounds close, I think I have one for my bimmer for changing the oil. Not deep though.
anyone know for sure?
|
103720, RE: socket size?
Posted by talon749, Apr-03-07 10:26 AM
I just ran out to the garage and checked, on my 95 block (I highly doubt it would change though the years), its a 24mm
|
103787, RE: socket size?
Posted by xceler8, Apr-07-07 03:31 PM
Thanks a lot for going to check. I got a little over 500 miles now, doing an oil cahnge at about 6-700 I think and going to start into some more boost.
Peace-
Props to you my friend.
|
103827, RE: socket size?
Posted by talon749, Apr-09-07 09:58 AM
Originally posted by xceler8
Thanks a lot for going to check. I got a little over 500 miles now, doing an oil cahnge at about 6-700 I think and going to start into some more boost. Peace- Props to you my friend.
no problem at all, good luck!
|