| Go back to previous topic |
| Forum name | Performance/Engine |
| Topic subject | Prothane motor mount inserts |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=103625 |
103625, Prothane motor mount inserts
Posted by BoostedEclipse, Mar-25-07 12:54 PM
I just bought the full set of prothane motor mounts. Well the front and rear were easy enough. But, the two mounts on the sides are a bitch. It says on the directions to get the oem rubber mounts pressed out and just pop the others in. Well I took it to a shop to get them pressed out and they tried to but were unable to get them out. How the F*** am I suppose to get them out. HELP!!!!!!!!!!!
|
103626, RE: Prothane motor mount inserts
Posted by talon749, Mar-25-07 01:30 PM
http://dsmtuners.com/forums/showthread.php?t=246706
a pretty good write up on how to do it
|
103627, RE: Prothane motor mount inserts
Posted by MitsuEclipseGS, Mar-25-07 01:59 PM
That is pretty much how I did mine except I use a dremel with a cutting drill bit.
-Todd
|
103628, RE: Prothane motor mount inserts
Posted by foggy45, Mar-25-07 03:18 PM
i machined a solid aluminium plug on my lathe the same size and depth as the ring and just pressed mine out with my 5-ton press.
note that the pass and driver side are different size rings.
|
103629, RE: Prothane motor mount inserts
Posted by 97esiboosted, Mar-25-07 04:36 PM
sawzall!!!
|