does anyone know where the evap system goes? Which ling goes to the gas tank and which line goes to the intake manifold? I need to finish my removeal and my manuals arent around... Thanks

Ok, i got all the line going to the throttle body, not i just gotta find the line that goes to the gas tank and put a breather filter or something on it or rip it out completely, what do you think?

what are the 02 wires on the factory o2 sensor? whites are for the heater? black is ground and gray is signal? So my a/f gauge that has a red, black and purple, i would hardwire the grounds together, and the greay and purple(signal), what about the red? tap onto one of the heater wires or what? I it wires to the bosch that came with the accel dfi, but i've fouled out all my o2 sensors with leaded gas... so i went cheap with ntk replacements this time...

Brad,

Not to sound like a jerk, but what are the advantages to removing the EVAP system?



Eric Madden

ahh, i'm a clutter freak. its a waste of space in my oppinion, and my car will be drag only when its paid off probably... its pretty much useless, all it does is remove gas vapor from the gas tank and dump it into your intake manifold, yippie, lets put hot exhaust gas vapor in the manifold of which we just put a fmic on to cool the temps down... same with the egr crap... just rip it all out, vent the vapor in the air, and enyou a little less clutter under the hood... unless you have to pass emisions.. then keep it and the e gr for safemeasure

Yeah the EGR system sucks, I had my mani ported and polished (maybe honed later) and I didn't want all black crap dumped into it so I took off the EGR system.



Eric Madden

you can get a plug in replacement bosh o2 sensor from discount auto parts. it will b ea different part number (the one accell uses is discontinued). the plug will be same 'though. cost me 40-50 bucks

bring it on............