| Go back to previous topic |
| Forum name | Performance/Engine |
| Topic subject | lots of codes after rebuild |
| Topic URL | https://forums.2gnt.com/dcboard.php?az=show_topic&forum=i5&topic_id=101166 |
101166, lots of codes after rebuild
Posted by xavier3jr, Sep-26-06 12:03 PM
p0403 EGR valve ( its blocked of)
p0443 evap emmisions ( took it off)
p0118 engine coolant temreature circut high input (????)
p0149 02 sensor circuit no activity detected bank 1 sensor 2(??????)
p1296 multi-faults-bank 2-with low side shorts (?????)
p1294 injector high side open 0 bank 2/target idle not reached(??????)
i need help with the ones that have ? marks beside them i have no clue what they mean
|
101168, RE: lots of codes after rebuild
Posted by DR1665, Sep-26-06 01:59 PM
p0118 engine coolant temreature circut high input (????)
Check your coolant temp sensor. Make sure you connected it back up. If you did, it could be that it shit the bed during r/i. Kinda goes without saying that you should check the connections on your O2 sensor.
|
101171, RE: lots of codes after rebuild
Posted by BlackMagic, Sep-26-06 05:16 PM
Did you already disconnect the battery for a minute or two and reconnect it?
|
101173, RE: lots of codes after rebuild
Posted by Star Turbo Talon, Sep-26-06 07:12 PM
sounds like a bad ground someplace
|
101181, RE: lots of codes after rebuild
Posted by Blizare, Sep-28-06 04:31 AM
I would reset the ecu again and see what happens only after checking to see if the connections for the 02 sensors and clt temp.
|