Go back to previous topic
Forum namePerformance/Engine
Topic subjectFuel pump picture and no drilling
Topic URLhttp://forums.2gnt.com/dcboard.php?az=show_topic&forum=5&topic_id=100121
100121, Fuel pump picture and no drilling
Posted by Star Turbo Talon, Dec-31-69 06:00 PM
The GSS342 walbro install without drilling any hols in the bracket and my AN fitting.










Terry
100135, RE: Fuel pump picture and no drilling
Posted by Chamuko, Dec-31-69 06:00 PM
explain pls
100136, RE: Fuel pump picture and no drilling
Posted by Star Turbo Talon, Dec-31-69 06:00 PM
Well, everyone swears the 342 walbro is too big for the bracket and you must drill another hole in the bottom piece. Everyone calls me a liar when i tell them you dont have to. Well here is proof.

The AN fitting is just something i did for my fuel setup. You need a 37 degree flare that will flare steel lines. It can be done with any 96+ fuel pump assy bracket. 95 is extremely hard to do and there is a great risk of damaging the steel line becaue you have to straighten it slightly.

Terry
100150, RE: Fuel pump picture and no drilling
Posted by turbo8u, Dec-31-69 06:00 PM
i didnt drill any hole either :shrug

super simple install
100155, RE: Fuel pump picture and no drilling
Posted by xcasbonx, Dec-31-69 06:00 PM
I just used Dino's method and used hose clamps. It worked good enough for me.


http://www.dsmregistry.com/detail.php?carid=1185
100158, RE: Fuel pump picture and no drilling
Posted by DR1665, Dec-31-69 06:00 PM


That looks almost pretty, Terry. Maybe you could polish it up a bit or something. ;) :thumbsup
100159, RE: Fuel pump picture and no drilling
Posted by Chamuko, Dec-31-69 06:00 PM
scrub it and you will take off the galvanized coating under it.
100313, RE: Fuel pump picture and no drilling
Posted by hs_elrod, Dec-31-69 06:00 PM
Originally posted by turbo8u
i didnt drill any hole either :shrug super simple install


Me neither, never heard of having to....
100327, RE: Fuel pump picture and no drilling
Posted by Star Turbo Talon, Dec-31-69 06:00 PM
search
I generated this page in 0.011843919754028 seconds, executing 7 queries.