ok, well I installed all of that today, but I am gonna have to wait till tomorrow to start it up, because the silicon needs to sit there for 16 - 24 hours. But I also have another question, After I took off my valve cover, I cleaned up everything, and put the gasket, and grommets in place on the valve cover, and then set it all in place and the gasket i got is blue, so after I put the cover back on, and bolted it down correctly, i could see about 1 - 1.5 mm of blue trim in between the valve cover, and head. Maybe i just now noticed it because the old gasket was grey, and really dirty. But I will find out if all this works tomorrow. anyubody know if that blue trim should be showing a little?