Hello Shocked has contacted me and wants me to build him a monster 2.4

But would like to have some input from all you guys also.

Here is what i have came up with so far.
(Motor Work will be done by VT Comp)
2.4 block
pauter x beam rods
CP Pistons compression ratio 8.5:1 coated by SwainTech ceramic and moly
possible oil attraction coating on the bearings
balanced and blue printed bottom end
Melling Oil Pump
mopar gaskets
srt4 timing belt tensioner
UR/AFX pulley
Bob Stockum Windage Tray
possible oil attraction coating on the engine bearings and pickup tube.

Cylinder head Port Work Done by NRGY Heads(Ex BlackDog Port Guy)
Ferrea valves coated with ceramic atleast (jury is still open 1mm or std)
full radius valve job(more surface area for valve to cool and also flows better)
coatings on the chambers and exhaust ports (ceramic)
crower springs and retainers
PT lifters and rockers
Crower or Crane Cams..
UR or Crane Cam gears

side notes the manifold and turbine housing will be ceramic coated

and also looking into jet hot coating the inside of the IC pipes.
(ceramic)

this is going to be matched to a Hahn RaceCraft Turbo Kit s25g with FMIC
recomended true 3" turbo back exhaust

my recomendation is for an AEM standalone equipped with a wideband

recomended drivetrain mods
axles
stage4 clutch with light flywheel
LSD and diff pin fix
solid motor mounts or atleast prothanes

Bill