| Go back to previous topic | | Forum name | Performance/Engine | | Topic subject | RE: Convert Rubber fuel supply line hose from Fuel Pump to SS? | | Topic URL | http://forums.2gnt.com/dcboard.php?az=show_topic&forum=5&topic_id=116419&mesg_id=127039 |
127039, RE: Convert Rubber fuel supply line hose from Fuel Pump to SS?
Posted by CODE4, Dec-31-69 06:00 PM
I decided not to run the original AN fitting setup I had on the pump bracket. It was brought to my attention that the compression fittings are only rated to 50 psi. Sure, I could maybe get away with it but I do not want to roll the dice.
My Ridgid JIC flaring tool arrived today. Practiced on an old shitty pump bracket to make sure those hard lines would flare nicely before installing the tube & nuts on the good one. Because of the awkward dimensions of the flaring tool I had to gently bend the hard lines out a bit to gain clearance. Worked out well though!
http://zero-signal.org/2.4L/pumpbracket_an-3.jp g
http://zero-signal.org/2.4L/pumpbracket_an-4.jp g
| |